OpenVMS VMS731_DQDRIVER-V0100 Alpha V7.3-1 ECO Summary
TITLE: OpenVMS VMS731_DQDRIVER-V0100 Alpha V7.3-1 ECO Summary
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
For OpenVMS savesets, the name of the compressed saveset
file will be kit_name.a-dcx_vaxexe for OpenVMS VAX or
kit_name.a-dcx_axpexe for OpenVMS Alpha. Once the OpenVMS
saveset is copied to your system, expand the compressed
saveset by typing RUN kitname.dcx_vaxexe or kitname.dcx_alpexe.
For PCSI files, once the PCSI file is copied to your system,
rename the PCSI file to kitname.pcsi-dcx_axpexe or
kitname.pcsi-dcx_vaxexe, then it can be expanded by typing
RUN kitname.pcsi-dcx_axpexe or kitname.pcsi-dcx_vaxexe. The
resultant file will be the PCSI installation file which can be
used to install the ECO.
Copyright (c) Hewlett-Packard Company 2003. All rights reserved.
OP/SYS: OpenVMS Alpha
SOURCE: Hewlett-Packard Company
ECO Kit Name: VMS731_DQDRIVER-V0100
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 192 Blocks
Kit Applies To: OpenVMS Alpha V7.3-1
System/Cluster Reboot Necessary: Yes
Rolling Re-boot Supported: Yes
Installation Rating: INSTALL_2 : To be installed by all customers using the
- DS15 Series Systems
The following remedial kit(s) must be installed BEFORE
installation of this kit:
In order to receive all the corrections listed in this
kit, the following remedial kits should also be installed:
FILES PATCHED OR REPLACED:
o [SYS$LDR]SYS$DQDRIVER.EXE (new image)
Image Identification Information
image name: "SYS$DQDRIVER"
image file identification: "X-35A3"
image file build identification: "X9TD-0060030012"
link date/time: 20-AUG-2003 16:20:53.32
linker identification: "A11-50"
PROBLEMS ADDRESSED IN THIS KIT
New problems addressed in the VMS731_DQDRIVER-V0100 kit
o SHOW DEVICE command shows error(s) after burning CD
Sometimes, when burning a CD using CDRECORD, the last
data bits would not be burned onto the CD. On some CD
drives the CD drive would get lost and stop responding to
commands. This was due to DQDRIVER timing out for some
CDRECORD commands. The user would always see at least 1
error with the CD drive after using CDrecord:
$ SHOW DEVICE DQA0
Device Device Error Volume Free Trans Mnt
Name Status Count Label Blocks Count Cnt
MY$DQA0: Online 1
o CDRECORD fails when writing to a DS25-based IDE CDROM
After installing the VMS731_EV7-V0100 or VMS731_EV7-V0200
ECO kits, CDRECORD fails when writing to a DS25-based IDE
Install this kit with the POLYCENTER Software installation utility
by logging into the SYSTEM account, and typing the following at the
PRODUCT INSTALL VMS731_DQDRIVER /SOURCE=[location of Kit]
The kit location may be a tape drive, CD, or a disk directory that
contains the kit.
Additional help on installing PCSI kits can be found by typing
HELP PRODUCT INSTALL at the system prompt
Scripting of Answers to Installation Questions
During installation, this kit will ask and require user response to
several questions. If you wish to automate the installation of
this kit and avoid having to provide responses to these questions,
you must create a DCL command procedure that includes the following
definitions and commands:
- $ DEFINE/SYS NO_ASK$BACKUP TRUE
- $ DEFINE/SYS NO_ASK$REBOOT TRUE
- Add the following qualifiers to the PRODUCT INSTALL command and
add that command to the DCL procedure.
- De-assign the logicals assigned
For example, a sample command file to install the
VMS731_DQDRIVER-V0100 kit would be:
$ DEFINE/SYS NO_ASK$BACKUP TRUE
$ DEFINE/SYS NO_ASK$REBOOT TRUE
$ PROD INSTALL VMS731_DQDRIVER/PROD=DEC/BASE=AXPVMS/VER=V1.0
$ DEASSIGN/SYS NO_ASK$BACKUP
$ DEASSIGN/SYS NO_ASK$REBOOT
COPYRIGHT AND DISCLAIMER:
(C) Copyright 2003 Hewlett-Packard Development Company, L.P.
Confidential computer software. Valid license from HP and/or its
subsidiaries required for possession, use, or copying.
Consistent with FAR 12.211 and 12.212, Commercial Computer
Software, Computer Software Documentation, and Technical Data for
Commercial Items are licensed to the U.S. Government under
vendor's standard commercial license.
Neither HP nor any of its subsidiaries shall be liable for
technical or editorial errors or omissions contained herein. The
information in this document is provided "as is" without warranty
of any kind and is subject to change without notice. The
warranties for HP products are set forth in the express limited
warranty statements accompanying such products. Nothing herein
should be construed as constituting an additional warranty.
DISCLAIMER OF WARRANTY AND LIMITATION OF LIABILITY
THIS PATCH IS PROVIDED AS IS, WITHOUT WARRANTY OF ANY KIND. ALL
EXPRESS OR IMPLIED CONDITIONS, REPRESENTATIONS AND WARRANTIES,
INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR
PARTICULAR PURPOSE, OR NON-INFRINGEMENT, ARE HEREBY EXCLUDED TO THE
EXTENT PERMITTED BY APPLICABLE LAW. IN NO EVENT WILL COMPAQ BE
LIABLE FOR ANY LOST REVENUE OR PROFIT, OR FOR SPECIAL, INDIRECT,
CONSEQUENTIAL, INCIDENTAL OR PUNITIVE DAMAGES, HOWEVER CAUSED AND
REGARDLESS OF THE THEORY OF LIABILITY, WITH RESPECT TO ANY PATCH
MADE AVAILABLE HERE OR TO THE USE OF SUCH PATCH.
Files on this server are as follows: