OpenVMS VMS731_LINKER-V0100 Alpha V7.3-1 LINKER ECO Summary
TITLE: OpenVMS VMS731_LINKER-V0100 Alpha V7.3-1 LINKER ECO Summary
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
For OpenVMS savesets, the name of the compressed saveset
file will be kit_name.a-dcx_vaxexe for OpenVMS VAX or
kit_name.a-dcx_axpexe for OpenVMS Alpha. Once the OpenVMS
saveset is copied to your system, expand the compressed
saveset by typing RUN kitname.dcx_vaxexe or kitname.dcx_alpexe.
For PCSI files, once the PCSI file is copied to your system,
rename the PCSI file to kitname.pcsi-dcx_axpexe or
kitname.pcsi-dcx_vaxexe, then it can be expanded by typing
RUN kitname.pcsi-dcx_axpexe or kitname.pcsi-dcx_vaxexe. The
resultant file will be the PCSI installation file which can be
used to install the ECO.
New Kit Date: 17-OCT-2002
Modification Date: Not Applicable
Modification Type: NEW KIT
Copyright (c) Compaq Computer Corporation 2002. All rights reserved.
OP/SYS: OpenVMS Alpha
SOURCE: Compaq Computer Corporation
ECO Kit Name: VMS731_LINKER-V0100
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 656 Blocks
Kit Applies To: OpenVMS Alpha V7.3-1
System/Cluster Reboot Necessary: No
Rolling Re-boot Supported: Information Not Available
Installation Rating: INSTALL_3
3 - To be installed by customers experiencing the problems
The following remedial kit(s) must be installed BEFORE
installation of this kit:
In order to receive all the corrections listed in this
kit, the following remedial kits should also be installed:
ECO KIT SUMMARY:
An ECO kit exists for LINKER on OpenVMS Alpha V7.3-1. This kit addresses the
PROBLEMS ADDRESSED IN VMS731_LINKER-V0100 KIT
o This change increases the RMS I/O related parameters when
doing I/O to the image file and map. This will result in an
increase in performance and reduce link time.
No reboot is necessary after successful installation of the kit.
Install this kit with the POLYCENTER Software installation utility
by logging into the SYSTEM account, and typing the following at the
PRODUCT INSTALL VMS731_LINKER-V0100 /SOURCE=[location of Kit]
The kit location may be a tape drive, CD, or a disk directory that
contains the kit.
Additional help on installing PCSI kits can be found by typing
HELP PRODUCT INSTALL at the system prompt
All trademarks are the property of their respective owners.
Files on this server are as follows: