OpenVMS VMS73_AUDSRV-V0100 Alpha V7.3 AUDSRV ECO Summary
TITLE: OpenVMS VMS73_AUDSRV-V0100 Alpha V7.3 AUDSRV ECO Summary
New Kit Date : 04-OCT-2001
Modification Date: Not Applicable
Modification Type: New Kit
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
For OpenVMS savesets, the name of the compressed saveset
file will be kit_name.a-dcx_vaxexe for OpenVMS VAX or
kit_name.a-dcx_axpexe for OpenVMS Alpha. Once the OpenVMS
saveset is copied to your system, expand the compressed
saveset by typing RUN kitname.dcx_vaxexe or kitname.dcx_alpexe.
For PCSI files, once the PCSI file is copied to your system,
rename the PCSI file to kitname.pcsi-dcx_axpexe, then it can
be expanded by typing RUN kitname.pcsi-dcx_axpexe. The resultant
file will be the PCSI installation file which can be used to install
Copyright (c) Compaq Computer Corporation 2001. All rights reserved.
OP/SYS: OpenVMS Alpha
SOURCE: Compaq Computer Corporation
ECO Kit Name: VMS73_AUDSRV-V0100
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 304 Blocks
Kit Applies To: OpenVMS Alpha V7.3
System/Cluster Reboot Necessary: No
Rolling Re-boot Supported: Information Not Available
Installation Rating: INSTALL_1
1 - To be installed on all systems running
the listed version(s) of OpenVMS.
The following remedial kit(s) (or later) must be installed BEFORE
installation of this kit:
In order to receive all the corrections listed in this
kit, the following remedial kits should also be installed:
ECO KIT SUMMARY:
An ECO kit exists for OpenVMS Alpha V7.3. This kit addresses the
PROBLEMS ADDRESSED IN VMS73_AUDSRV-V0100 KIT:
o Digital command language (DCL) does not regain control when
the SET SECURITY command is issued. When this occurs, the
profile for the object in question may not be updated on all
nodes in a cluster environment.
Images Affected: [SYSEXE]AUDIT_SERVER.EXE
No reboot is necessary after successful installation of the kit.
Install this kit with the POLYCENTER Software installation utility
by logging into the SYSTEM account, and typing the following at the
PRODUCT INSTALL VMS73_AUDSRV /SOURCE=[location of Kit]
The kit location may be a tape drive, CD, or a disk directory that
contains the kit.
Additional help on installing PCSI kits can be found by typing
HELP PRODUCT INSTALL at the system prompt.
Once the new image is installed, restarting the Audit_Server is all
that is required to correct the problem described above. The
following sequence of commands completes the task:
$ SET AUDIT/SERVER=EXIT ! Stop Execution of current
$ SET AUDIT/SERVER=START ! Start new AUDIT_SERVER
$ SET AUDIT/SERVER=INIT ! Enable AUDIT and OBJECT
All trademarks are the property of their respective owners.
Files on this server are as follows: